Every safety recall published by the Australian government, searchable and filterable.
After certain repairs, some vehicles may experience a high resistive short at the vanity lamp wiring due to a trapped wire.
The right hand drive shaft may separate due to overextension of the driveshaft in certain conditions.
A durability condition has been identified where the LPG Fuel Feed Hose may develop a very slow leak towards the end of the vehicle’s lifetime. In this circumstance, fuel may leak…
Due to inappropriate production/storage of the propellant in the inflator of the passenger-side airbag, the density of the propellant may be insufficient. As a result, the propella…
It cannot be ruled out that the piston rod of the rear spring strut, in connection with the Dynamic ESA option, could break.
Load cycle shifts occurring when the vehicle is on the move causes pressure spikes in the engine oil at the shaft seal and these pressures can force the shaft seal out of its seat…
A condition has been identified where the pretensioner wiring harness may make contact with a bolt at the base of the seat belt buckle assembly. As a result the wiring harness may…
Airbag module retention bolt could be incorrectly tensioned.
Failure during the welding process has potentially reduced the welding strength of the filler pipe. With continued use the subject welding portion could detach.
The spiral cables' electrical connection for the driver's side airbag module may become damaged over time. If this occurs, the airbag warning light will illuminate and the driver'…
There is a possibility that an O-ring seal located between the Fuel Delivery Module and the wiring connector insert of the LPG tank may be missing.
There is a possibility that an O-ring seal located between the Fuel Delivery Module and the wiring connector insert of the LPG tank may be missing.
Due to incorrect material used and routing of the fuel tank breather tube (main to sub-tank) near the exhaust, the breather tube may be damaged by heat from the exhaust which could…
The software used to control the boost converter contained within the hybrid system intelligent power module, during high-load driving such as accelerating from a stop, may cause h…
Certain vehicles may have been built with a fuel feed hose that may be in contact with the Air Conditioning Suction pipe. Over time, the fuel feed hose may rub against the A/C suc…
Due to incorrect tolerances in the driveline, corrosion may occur between the inner bearing race of the needle roller bearing and the bearing seat of the input shaft, possibly comp…
A concern has been identified where the battery positive cable on 2014 model year Range Rover Sport SDV6 vehicles fitted with Dynamic Response System (DRS) suspension system may cl…
There is a possibility of improper welding on front propeller shafts manufactured prior to Friday, 25 November 2011, which may result in the weld failing. If the weld fails, the f…
A limited number of Amarok vehicles had fuel pipes incorrectly positioned during production. This defect, combined with vibrations in the engine bay, may lead to chafing or cracks…
The connection between the fuel return pipes and the injectors may have been damaged during assembly in the factory.
Some of these motorcycles may exhibit a condition in which the hydraulic clutch system may lose the ability to generate enough lift to disengage.
Some of these motorcycles may exhibit a condition in which the hydraulic clutch system may lose the ability to generate enough lift to disengage.
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…