Every safety recall published by the Australian government, searchable and filterable.
Hydrogen may have become embedded in the material of the pistons of a certain batch of brake calipers. This hydrogen could leak from the pistons and enter the hydraulic components…
A combination of the front draw bar design (mounting bolt hole) and the incorrect material being used may result in fatigue cracks or the draw bar separating from the trailer.
The wiring harness of the SRS electronic control unit could become severed if the vehicle is in a severe collision.
The brake pad may separate from the backing plate.
The rear brake calipers may have incorrect chrome coating on the pistons, which may cause gas pockets to form in the brake system. In some instances, the brake pedal may exhibit in…
On certain vehicles, after several hard brake applications, the brake light pressure switch may not activate the brake lights with a light application of the brake pedal.
The top tether anchorage point at the centre position of the rear seat bench may be missing.
A fault in the Power Control Module (PCM) software may affect cruise control, potentially causing the vehicle speed to lock or unexpected vehicle acceleration.
If the powertain control module fails, the driver may experience a no-start, a start-and-immediate stall condition, or an engine stall while driving.
Affected vehicles may be fitted with a Front Lower Control Arm with faulty welds. Lower Control Arm weld failure could cause the front wheel assembly to hit the wheelhouse and/or f…
The front windscreen wiper motor venting device may allow water to enter the wiper motor, causing corrosion and motor failure.
The auxiliary heater element in the air conditioner may fail as a result of overheating in the area of the connectors.
A fault with the halfshaft assembly resulting in loss of power or inability to PARK the vehicle. The vehicle can crash without prior warning and cause vehicle occupants or bystande…
The left cutout for the exhaust system is missing in some incorrectly installed paneling.
The auxiliary heater element in the air conditioner may fail as the result of overheating in the area of the connectors.
If the vehicle has a faulty rear seat latch and the rear seat belts are not fastened and the vehicle is involved in a collision, this could cause the rear seats to unlatch and uni…
On affected vehicles, the cooling strategy and maximum temperature alert might cause engine overheating.
There is a possibility of air being trapped in the hydraulic braking system.
The engine may not restart after being switched off.
If the engine overheats this can result in an oil leak, leading to loss of engine oil.
If the motorcycle is used continuously at high speed, the heat generated may cause the clutch basket to break.
The laser welding between the backrest member and backrest fitting may not comply with specifications in the driver and front-passenger seats and may not withstand the required loa…
The connecting links on the rear anti-roll bar cannot be guaranteed over the service life of the vehicle due to a manufacturing defect.
The seatbelt buckles for the rear right and rear centre seating positions may have been torqued incorrectly.
The bolt fixing the drive chain guard to the swing arm may loosen due to vibration during riding because of inappropriate design.