Every safety recall published by the Australian government, searchable and filterable.
The fuel gauge may show there is sufficient fuel even though the car has run out of fuel.
The under floor mounted diesel fuel cooler may leak. A fuel odour may be noticed and over time, drivers may notice an increase in fuel consumption and in some cases liquid fuel pud…
There is a possibility that due to insufficient strength of the gear shift rear shaft, some vehicles may have a problem with the gear shift shaft under certain conditions.
There is a possibility that due to insufficient strength of the gear shift rear shaft, some vehicles may have a problem with the gear shift shaft under certain conditions.
If the fuel tank is overfilled, particular handling conditions could cause fuel to reach the carbon canister. If this occurs, it may stop the EVAP system from managing fuel vapours…
The mixture of chemicals used in front passenger airbags on certain vehicles may not meet specification, which may result in the initiator not properly functioning and the front pa…
The stator coil charge may be reduced due to insufficient insulation material around the wiring inside the stator that could become affected by engine heat, causing the battery to…
The structure of the front deck of the vehicle allows water intrusion onto the windshield wiper motor, which is drawn into the motor's breather hole as it cools down after use.This…
The waterproof boots of the throttle cable may deteriorate and allow water to penetrate.
A software error may cause an inoperative dipped beam, main beam, daytime running light, rear fog light or indicator bulb to not be indicated to the driver. Operative bulbs may als…
The tooth flank depth in the serration of the splines may not be sufficient for the required transmission of force between the steering column and the spindle.
Poor weld penetration on 10" Electric brake mount flanges welded to stub axles on beam axles and independent suspension rubber axles fitted to caravans and camper trailers.
The installation of the under floor fuel pipe assembly has insufficient clearance between the under floor fuel pipes and the vehicle under shield and body, leading to a chafe condi…
The fastening pivot of the side stand may become slack.
The rear axle may have an insufficiently tightened Panhard Rod bolt, due to a production error.
The air-gap between the end of the throttle twist grip rubber and the handlebar end weight on heated handlebar grips may be too small. This could cause the grip (when heated) to ex…
There is a possibility that front side airbags with incorrect detonator units were installed as a result of a supplier’s manufacturing error.
There is a possibility that the fastening screws for the fuel collection pipes on the affected vehicles can loosen and shear off.
The fuel tank wall thickness may be below the design specification.
Due to corrosion, the striker wire on the bonnet support may prove insufficiently secure for its intended purpose.
The engine harness may have been routed incorrectly and as a result could contact the water charge air cooler bracket. Vibration of the engine may cause chafing that results in the…
The driver side power seat switch may not operate properly when driving.
The left hand lower control arm to the knuckle joint in the front suspension has been incorrectly assembled. If the vehicle is exposed to a shock impact such as a deep pothole or k…
The right hand lower control arm to the knuckle joint in the front suspension has been incorrectly assembled. If the vehicle is exposed to a shock impact such as a deep pothole or…
On certain motorcycles, there may be insufficient clearance between the fuel rail and the engine. This can result in abrasion of the fuel rail.