Every safety recall published by the Australian government, searchable and filterable.
The pin that supports the door gas springs may not have been assembled according to manufacturing specifications and could become loose and/or detach. If this occurs when in the op…
Due to improper assembly of the rear brake caliper, the brake pads may not contact the brake disc during braking. This could result in a reduction in braking performance.
The upper anchorage points for the seatbelts in the second-row left and right-hand seating positions may not meet load specifications. As a result, the seat belt may not operate as…
Due to a manufacturing issue, the passenger airbag inflator may rupture in the event of airbag deployment.
Due to a manufacturing defect, the fuel pump impeller may not operate as intended. If this occurs, it could impair the fuel supply to the engine and result in a loss of motive powe…
Due to an error in the SYNC software, the rear-view camera may not display the rear-view image whilst reversing or the rear-view image may remain on display after reversing. Additi…
The piston rings fitted to the engines of certain vehicles may not meet manufacturing specifications, and could cause engine failure and vehicle stalling.
Due to a manufacturing defect, the retaining studs under the driver’s seat may not have a safety sealing cap installed during assembly.
Due to a manufacturing defect, the outer head restraints of the rear row seats may not be manufactured correctly. As a result, they may move or detach from the seat in an event of…
Due to a manufacturing defect, the threaded connection between the high-pressure fuel pump and the fuel rail may become loose. If this occurs, fuel may leak in the presence of an e…
Due to a manufacturing defect, the steering shaft pinch bolt may have been incorrectly installed. This could result in a loss of steering control.
Due to a software issue, if the occupants exit the driver and/or front passenger doors using the interior mechanical release handles when the12 volt battery is discharged and the d…
Due to a manufacturing defect, the passenger airbag may tear during deployment. This could cause hot gas to escape from the airbag and result in insufficient protection to the pass…
The forward-facing seat brackets in the rear compartment of the campervan do not comply with the requirements of Australian Design Rule (ADR) 5/06 - Anchorages for Seatbelts and ma…
Due to a software programming issue, a memory device in the Combination Meter may deteriorate over time. If this occurs, the Combination Meter display may remain blank when the veh…
Due to a software programming issue, a memory device in the Combination Meter may deteriorate over time. If this occurs, the Combination Meter display may remain blank when the veh…
Due to a manufacturing defect, the passenger airbag may tear during deployment. This could cause hot gases to escape from the airbag and result in insufficient protection to the pa…
The seat brackets in the rear cabin do not comply with Australian Design Rule (ADR 03/04) - Seats and Seat Anchorages requirements and may fail.
Due to a manufacturing defect, the sockets fitted to the turn signal lamps in the front headlight assembly may overheat and melt. If this occurs, the turn signal indicators may not…
Due to a manufacturing defect, moisture may enter the bumper wiring harness causing corrosion. This could result in reduced efficiency of the power assisted steering and a loss of…
Due to a manufacturing issue, the right and/or left curtain airbag/s may be fitted with a faulty gas generator. As a result, the airbags may not deploy as intended.
Due to a manufacturing defect, the engine crankcase clamping retainers may have been overtightened. This could result in seizure of the crankshaft bearing material, abnormal noise…
Due to a manufacturing defect, the retaining bolts on the left and right-side curtain airbags may not have been fastened with sufficient torque. As a result, the airbags may not de…
Due to a manufacturing defect, the child lock feature on the dual power sliding door may not operate as intended. As a result, the sliding door may be opened from the inside using…
Due to an incorrectly manufactured High-Pressure Fuel Pipe, poor sealing of the fuel system may occur resulting in a fuel leak.