Every safety recall published by the Australian government, searchable and filterable.
The fuel gauge may show there is sufficient fuel even though the car has run out of fuel.
There is a possibility that due to insufficient strength of the gear shift rear shaft, some vehicles may have a problem with the gear shift shaft under certain conditions.
There is a possibility that due to insufficient strength of the gear shift rear shaft, some vehicles may have a problem with the gear shift shaft under certain conditions.
The stator coil charge may be reduced due to insufficient insulation material around the wiring inside the stator that could become affected by engine heat, causing the battery to…
The structure of the front deck of the vehicle allows water intrusion onto the windshield wiper motor, which is drawn into the motor's breather hole as it cools down after use.This…
The waterproof boots of the throttle cable may deteriorate and allow water to penetrate.
A software error may cause an inoperative dipped beam, main beam, daytime running light, rear fog light or indicator bulb to not be indicated to the driver. Operative bulbs may als…
There is a possibility that front side airbags with incorrect detonator units were installed as a result of a supplier’s manufacturing error.
The driver side power seat switch may not operate properly when driving.
The left hand lower control arm to the knuckle joint in the front suspension has been incorrectly assembled. If the vehicle is exposed to a shock impact such as a deep pothole or k…
The right hand lower control arm to the knuckle joint in the front suspension has been incorrectly assembled. If the vehicle is exposed to a shock impact such as a deep pothole or…
The rear suspension leaf springs may not conform to the required standard.
There is a possibility that an intermittent Output Shaft Speed Sensor failure may result in an unintended downshift into first gear.
The main switch wire lead is routed near a metal cable guide located on the steering head. Through normal use, there is a possibility that the wire lead may be worn by the metal gu…
The affected vehicles have tyre valves fitted that could be defective, resulting in a loss of tyre pressure.
On the involved vehicles the related gear position (P_R_N_D) may not match the expected vehicle behavior, i.e. unable to shift out of Park or shift out of a forward or reverse driv…
The Ambient Temperature Sensor Malfunction Indicator Light (MIL) may not illuminate due to an incorrect software programme.
Affected vehicles are equipped with a single latch system on the side sliding doors which does not meet the requirements of the relevant Australian Design Rule (ADR).
The Ambient Temperature Sensor Malfunction Indicator Light (MIL) may not illuminate due to an incorrect software programme.
The affected vehicles equipped with continuously variable transmission may experience a delay in the vehicle's acceleration.
There is a possibility that due to a software error within the Headlight Control Module (HCM), vehicles fitted with Adaptive LED Headlamps could experience a condition that causes…
The headlights may not have been correctly adjusted during production.
Affected vehicles equipped with a continuously variable transmission (CVT) may, in certain driving conditions, experience a delay in the vehicle’s acceleration.
The clearance between the transmission/alternator wiring harness and the exhaust system may not be sufficient; this may result in damage to the wiring harness. As a result it may n…
A manufacturing defect within the fuel pump may lead to reduced performance and affect the long term durability of the fuel pump.