Every safety recall published by the Australian government, searchable and filterable.
A joint on the drive shaft may come loose resulting in a loss of drive.
On affected vehicles, it is possible that the glass panel is insufficiently bonded to the sliding sunroof frame due to the bonding surfaces not being clean during the production pr…
The driver airbag performance is outside of the required specification for time to inflate due to a malformed canister. In this condition, the flow of the gas generated for airbag…
The recliner mechanisms fitted to the 2nd row (60% side, with left and centre seats) may not lock correctly when the seat back is placed into the upright position.
The brake fluid reservoir may not have been properly secured during production.
The bonnet secondary safety latch has a risk of being unlatched when the vehicle is in motion. Under certain conditions the bonnet can lift suddenly and block the front vision of t…
The engine may not start, or may cut out without warning. If the engine cuts out, the vehicle will lose brake power assistance and Power Assisted Steering (PAS) will also be lost,…
The front fender bracket may fail causing the front fender to become loose.
The engine may not start, or may cut out without warning. If the engine cuts out, the vehicle will lose brake power assistance and Power Assisted Steering (PAS) will also be lost,…
Due to a software concern within the engine control unit the engine may stall when braking at low speed.
The fuel suction plate located within the fuel tank may develop a crack which could expand over time. In this condition, fuel may eventually leak when the vehicle has a full tank…
An incorrect propeller shaft angle causing a risk of the universal joint overheating and breaking.
The clock spring on certain vehicles may ingest dust if the vehicle is subjected to extremely dusty environments.
The clock spring on certain vehicles may ingest dust if the vehicle is subjected to dusty environments.
Unburned fuel can be routed in to the exhaust system, which can cause elevated exhaust temperatures.
There is a defect in the electronic power steering gearbox in certain 11MY Colt vehicles. Due to improper crimping of the terminal connection between the steering force torque sens…
The detent lever of the child lock can break because it was damaged during the production process. As a result of this an active child lock can unnoticeably be switched off. This m…
The clutch pressure plate bearing may fail when operated frequently. The oil pump drive gear may break due to excessive stress.
The resistance of the insulated base of the Motor Control Unit (MCU) may increase. As a result the circuit voltage may become unstable, causing the malfunction lamp to illuminate a…
Due to a running vehicle wiring harness design change at Mitsubishi, the electric trailer brake accessory harness that Mitsubishi had been selling is not suitable for 16MY Outlande…
Curtain shield air bag inflators located in the driver and passenger side roof rails are composed of two chambers welded together. Some inflators could have a small crack in the we…
An inappropriate manufacturing process of an electrical part on a manufacturing line may cause the voltage inside the ETACS ECU to be unstable.
The brake warning lamp may illuminate due to improper software judgement that the vacuum pump relay has seized. On selected vehicles the location of the brake vacuum pump exhaust m…
The turn signal and lighting switch connector terminals may become worn during switch operation due to insufficient rigidity. This may result in an accumulation of oxidised dust on…
The rear right hand side parking brake cable may interfere with fuel tank and may result in damage to the protective coating of the fuel tank.