Every safety recall published by the Australian government, searchable and filterable.
The Occupant Restraint Control (ORC) module has a software error.
Moisture can penetrate the plug-in connection of the adapter cable on the Electric Power Steering - EPS.
The vehicles' supplementary electric vacuum pump may not work when the engine is cold.
The programmed setting on the ECU (Electronic Control Unit) is incorrect.
The ABS unit is required to be checked for a possible foreign particle, which may become trapped in either the inlet or the outlet valve.
The charge air cooler (CAC) hose can detach from the charge air cooler resonator.
Land Rover has identified diesel fuel leaking from the engine mounted injector spill rail spigot to spill return pipe connector joint.
Jaguar has identified diesel fuel leaking from the engine mounted injector spill rail spigot to spill return pipe connector joint.
An internal short-circuit may occur in the area of the electric contacts of the diesel fuel filter heating unit.
The ABS modulator may be defective.
When the gear selector is set to the “park” position, the parking pawl may not engage and therefore the parking mechanism may not operate properly. In this case (assuming the parki…
Over time the side stand could work loose, causing it to become unattached from the motorcycle. Additionally, the side stand switch may not work reliably and the engine will not sh…
n both models the plastic fuel elbow may crack during removal.In addition, the TE 310 MY13 model requires a fuel tank lift kit to be installed. The fuel tank lift kit will add more…
A condition has been identified where, in some instances, an incorrect diaphragm spring was installed within the LPG vaporiser that may comprimise the diaphragm. When the diaphragm…
It is possible that the fuel pipes may have been incorrectly manufactured or not tightened correctly and could crack.
The brake vacuum hose may have been supplied without an internal check valve. When the engine is not running, this may lead to a loss of brake vacuum assistance.
A manufacturing fault has been found with the double connecting rod.
It has been identified that the heater blower motor may jam, causing the resistor fuse to possibly over-heat and cut out.
It has been identified that the heater blower motor may jam, causing the resistor fuse to possibly over-heat and cut out.
The intermediate steering shaft might have been fitted incorrectly in some vehicles.
The ABS unit for the brakes may contain aluminium debris due to a manufacturing error.
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
The potential defects or combination of defects are as follows:(1) The Electronic Power Steering computer may fail, causing the EPS warning lamp to illuminate and in the worst cas…
It is possible that the park brake lever lock nut has not been correctly tensioned. This may result in damage to the park brake cable.