Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue, the Pilot Assist System may not operate as intended and fail to alert the driver if the steering wheel is not being held.
Due to a manufacturing defect, the wheel lug nuts may not have been tightened sufficiently and could become loose. As a result, the wheel may detach from the brush chipper whilst b…
Due to a manufacturing defect, the front brake hoses may be defective. This may lead to a brake fluid leak resulting in a reduction in braking performance.
The mounting bolts and nuts that are used to secure the axle assembly to the frame of the brush chipper may not have been tightened correctly. If the axle mounting bolts loosen, th…
Due to a software issue with the Anti-Lock Brake System (ABS), the Electronic Stability Control (ESC) may fail. This may result in a loss of vehicle control.
Due to a manufacturing issue, a retaining screw between the vehicle’s electrical wiring and the fuse box located in the front passenger footwell may not have been tightened suffici…
Due to a software issue, the Adaptive Cruise Control (ACC) function may not operate as intended. This may cause the vehicle to exceed the maximum speed limit of 100 km per hour if…
Due to an issue with driver seat occupancy switch, the instrument cluster may fail to illuminate the visual and audible seat belt warnings in certain conditions as required by the…
Due to operation of the seat back rest, the driver and passenger side air bag wiring harnesses may become damaged over time caused by seat adjustment. This could impair the deploym…
Due to a software issue with the airbag control unit, the pedestrian detection sensor may not function as intended.
Due to a manufacturing defect, under certain conditions the engine valve springs may crack. If this occurs, the engine could stall resulting in a loss of motive power.
The courtesy lamps, fog lamps and daytime running lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 13/00 - Installation of…
The side direction indicator lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 06/00 - Direction Indicators.The courtesy la…
The courtesy lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 13/00 - Installation of Lighting and Light-signalling Device…
The side direction indicator lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 06/00 - Direction Indicators.The courtesy la…
Due to a manufacturing defect, the gear shift shaft may have been incorrectly welded. As a result, the rider may be unable to change gears leading to a loss of motive power whilst…
Due to a manufacturing issue, the undercarriage of the affected trailers may experience stress, which could lead to the metal chassis cracking. As a result, components of the trail…
The seat brackets in the rear cabin do not comply with Australian Design Rule (ADR 03/04) - Seats and Seat Anchorages requirements and may fail.
The propeller shaft may not meet manufacturing specifications and could fail. As a result, the vehicle will experience a loss of motive power whilst driving.
The propeller shaft may not meet manufacturing specifications and could fail. As a result, the vehicle will experience a loss of motive power whilst driving.
The Gear Drive Unit (GDU) assembly bolts may not have been tightened to the torque sufficiently causing it to possibly fail and result in a loss of motive power.
Due to a software issue within the Engine Management Control (EMC) unit, the Hydraulic Brake Compensation (HBC) system may not operate as intended. This could lead to reduced braki…
Due to an improper manufacturing process, a component within the fuel pump could swell causing the fuel pump to become inoperative.
A software issue in the Battery Management System (BMS) may cause deactivation of the high voltage battery. As a result, the vehicle may experience a loss of propulsion whilst driv…
The clutch plates within the hybrid transmission may not meet manufacturing specifications. As a result, the clutch plates may overheat causing material degradation and potential t…