Every safety recall published by the Australian government, searchable and filterable.
The rear spare wheel carrier U-bolt may not meet manufacturing specifications. As a result, the rear spare wheel carrier could detach from the vehicle.
Due to a software issue, the visual and acoustic warning system may not alert the driver if other vehicles and/or traffic are approaching when exiting the vehicle.
Due to a manufacturing defect, the vehicle power electronics system wiring harness may come in contact and chafe against the underbody paneling. As a result, the wiring harness cou…
The front windshield wipers may fail. In the event of rain this may lead to poor visibility for the driver.
Due to a manufacturing defect, the High-Pressure Fuel Pump could fail prematurely and introduce failed component debris into the fuel system. This could impair the fuel supply to t…
Due to a manufacturing defect, the rear axle radial shaft ring may not be sealed adequately. This could cause an oil leak resulting in an unexpected reduction of braking performanc…
The outer seat belts in the second row may become jammed at the bottom of the trim panels. As a result, the seat belts may not operate as intended.
Due to a manufacturing issue, the battery ground point connection bolts may not have been tightened to specification. This could increase the electrical resistance of the connectio…
Due to a manufacturing issue, the battery ground point connection bolts may not have been tightened to specification. This could increase the electrical resistance of the connectio…
Due to a manufacturing issue, the battery ground point connection bolts may not have been tightened to specification. This could increase the electrical resistance of the connectio…
Due to a manufacturing defect, the transmission may experience a build-up of pressure and heat causing transmission fluid to leak. A transmission fluid leak in the presence of an…
Due to a manufacturing issue, the relay for the air heater intake may experience an electrical short. This may occur when the ignition is On or OFF and could result in an engine co…
Due to a manufacturing defect, the fuel pump may fail. This could restrict the fuel supply to the engine and result in a loss of power whilst riding. Under certain conditions, if t…
The rear crossmember may not have been manufactured according to specifications and could crack. If this occurs, the vehicle could experience a sudden loss of vehicle control.
Due to a manufacturing defect, the front right drive shaft may become loose and detach from the eDrive. If this occurs, it could lead to a sudden loss of motive power.Note: In an e…
Due to a manufacturing defect, the high voltage coolant heater (HVCH) may not operate as intended. If this occurs, the vehicle occupant may not be able to defrost the windscreen an…
Due to a manufacturing defect, the front left drive shaft may become loose and detach from the eDrive. If this occurs, it could cause a sudden loss of motive power.Note: In an even…
Due to a manufacturing defect, the fuel delivery unit may fail causing the fuel pump to switch off. If this occurs, it could impair the fuel supply to the engine resulting in a los…
Due to a manufacturing defect, the bonding of the inner and outer window panes may deteriorate over time. As a result, the outer window pane may detach from the vehicle.
The internal circuit board of the winches remote control can corrode if exposed to water. If corrosion of the circuit board occurs, the winch can cause the cable to stop, wind up o…
The fuse power stud located in the battery box may corrode over time. This may cause an electrical short circuit with the mounting bracket and could result in a vehicle fire.
Due to a manufacturing defect, the left front suspension ball joint may have been incorrectly attached. This may result in a loss of vehicle control.
If the subject vehicles are continuously operated without inspection, the engine may exhibit abnormal noise and potentially seize. This may cause a sudden loss of motive power and…
Due to a manufacturing defect, the rear-view camera wiring harness may become damaged and could cause the rear-view image to become distorted or flicker.
Due to a manufacturing issue, the joint between the coolant pipe and the temperature sensor may not be sealed adequately. This could cause a coolant leak resulting in a vehicle fir…