Every safety recall published by the Australian government, searchable and filterable.
Due to a software fault in the vehicle’s Electronic Control Unit (ECU) the engine may stall resulting in an unexpected loss of vehicle control.
Due to a manufacturing defect, the valve between the engine and the vacuum assist brake booster may swell under certain conditions. As a result, an increased brake pedal effort may…
The design of the rear wall cabinets is not sufficient to ensure their integrity is maintained in the case of a frontal collision.
Due to a manufacturing issue, the transmission wiring may have been routed incorrectly and may contact the front driveshaft. This may result in an unexpected loss of traction.
The piston rings fitted to certain vehicles may not meet manufacturing specifications and could cause engine failure and vehicle stalling. This will result in an unexpected loss of…
The front suspension torsion bar may not have screwed into the torsion bar linkage as per specifications. This could cause reduced stability while driving at high speed and result…
Due to a manufacturing issue, the rear wheel bearing housing may fracture. If this occurs it could result in loss of vehicle control.
The connection depth of the front towing point may not meet manufacturing specifications. As a result, the front tow point connection could detach from the vehicle during frontal t…
Due to a manufacturing defect, the driveshaft universal joint play may exceed the manufacturer's tolerance. If the vehicle continues to operate under these conditions, grease may l…
Due to a manufacturing defect, the high voltage battery does not meet specifications and may result in an electrical short circuit. If this occurs it may result in a vehicle fire.
Due to a manufacturing issue, the wheel hub assembly and suspension may collapse or detach from the vehicle. If this occurs the vehicle may experience a sudden loss of steering con…
Due to a manufacturing issue, the seat belt pre-tensioner inflator may fracture when deployed in the event of an accident.
Due to a manufacturing defect, the front axle brake line hose(s) may become dislodged from the end fitting crimp. This may cause a reduction in braking performance or an unintended…
The reverse lamps may not illuminate and the rear-view reverse camera may not display the rearwards image when reversing as intended.
Due to a manufacturing issue, the rear turn indicators may not illuminate correctly.
Due to a manufacturing defect, a damaged front seat belt pre-tensioner tube may have been installed on the seat belt retractor. As a result the seat belt pre-tensioner may not oper…
Due to a manufacturing defect, a damaged front seat belt pre-tensioner tube may have been installed on the seat belt retractor. As a result the seat belt pre-tensioner may not oper…
Due to a manufacturing defect, the brake booster may fail. If this occurs the stopping distance in the un-boosted condition would exceeds the distance prescribed by the Australian…
Due to a manufacturing issue, the Electronic Park Brake (EPB) adaptor cord connector may not operate as intended. This could result in vehicle moving or rolling away whilst the veh…
Due to a manufacturing defect, the rear window may have pressure on it as a seal has shrunk causing the window to shatter.
The front wheel well to body panels may not have been sealed according to manufacturing specifications. Moisture may enter the interior of the body via the front wheel wells and ca…
Due to a manufacturing issue, the Handlebar Stem bolt may break. If this occurs the vehicle may experience a sudden loss of steering.
The front engine shield and the Active Grille Shutter (AGS) system located under the front of the vehicle requires modifications. In the event of an engine failure and oil/fuel rup…
Due to a manufacturing issue, the oil supply in the oil strainer to the turbochargers may become clogged and affect engine operation.
Due to a software issue, the rear-view camera may not display the rear-view camera image as intended.