Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing issue with the wheel hub component, the wheel hub may become loose. If this occurs it may cause the wheel motors to seize.
Due to a software fault in the vehicle’s Electronic Control Unit (ECU) the engine may stall resulting in an unexpected loss of vehicle control accompanied by a warning light on the…
A software update issue may lead to an engine failure whilst driving and a red Check Control message "Drive faulty” may also appear.
The vehicle’s LCD instrument cluster screen may show an inverted image as a result of voltage fluctuations when operating at extremely low ambient temperatures, due to a discrepanc…
Due to its installation position, if there is liquid or liquid droplets spilt on the rear seat bench the control unit for network management may become damaged and fail.A failure o…
The previous replacement of the rear axle clamping nuts (as part of the recent recall REC-001665) may have caused a misalignment of the rear axle assembly. This could result in exc…
The vehicle's front radar sensor which supports certain driver assistance features, including the Pre-Collision System (PCS) may not have been calibrated during vehicle manufacture…
Due to a manufacturing issue, the transfer case blanking plug may not have been installed correctly during production. This may lead to an oil leak from the transmission.
The steering pivot joint bolts may not meet manufacturing specifications and may become loose. If the joint becomes loose the steering may deviate from its desired trajectory.
Due to a manufacturing issue, the throttle tube may break when excessive lateral pulling force is applied. If this occurs it may result in an unintended acceleration and a loss of…
Due to a manufacturing issue, the Airbag Control Unit (ACU) cover and the Electronically Erasable Programming Read-Only Memory (EEPROM) chip may have been produced with insufficien…
The previous replacement of the rear axle trailing arm clamping nuts (as part of the recent recall REC-001635) may have caused a misalignment of the rear axle assembly. This could…
Due to a software issue some functions of the Mercedes-Benz User Experience (MBUX) multimedia system may not deactivate when the vehicle starts moving. This can result in driver di…
Vehicles have been supplied with incorrect information in the owner’s manual in regards to the installation of ISOFIX child restraint system.
The front axle housing may not meet manufacturing specifications and may crack. If this occurs it may result in a loss of vehicle control.
Vehicles have been supplied with incorrect information in the owner’s manual in regards to the installation of ISOFIX child restraint system.
Due to a software issue, the automatic network search of the emergency call system (eCall) communication module may be deactivated. In this case, the automatic and manual emergency…
Due to a software issue related to the internal temperature of the instrument cluster, if the temperature of the instrument cluster is below 32 degrees Fahrenheit (0 degrees Celsiu…
Due to a manufacturing issue, the oil cooler hose may become damaged due to the radiant heat exposure from the exhaust pipes.
The steering column mounting bolts may not have been tightened sufficiently and could become loose or separate. This could result in a loss of steering.
Due to a manufacturing issue, the brake tube may become damaged and cause a brake fluid leak. This may result in a reduction in braking performance.
Due to a wiring issue with the airbag system, the airbag may not deploy as intended.
Under certain driving condition the vehicle fail-safe mode may be activated. If this occurs the EV ready lamp will flash accompanied with reduced acceleration and a loss of motive…
Due to a manufacturing issue, the sunroof frame may not have been bonded correctly to the body and could become loose and detach from the vehicle.
Due to a manufacturing issue, the locking mechanism on the front doors may not latch and could remain stuck in the open position.