Every safety recall published by the Australian government, searchable and filterable.
Due to a manufacturing defect, the left rear seat belt retractor mechanism may not operate as intended. As a result, excessive belt lengths may be released in the event of an accid…
Due to a manufacturing defect, the shielding ring in the high voltage wiring harness may not be properly grounded. This can reduce the effectiveness of electromagnetic shielding, w…
Due to a manufacturing defect, the left rear seat belt retractor mechanism may not operate as intended. As a result, excessive belt lengths may be released in the event of an accid…
Due to a manufacturing defect, the 12-volt battery vent may not operate as intended. As a result, under certain driving conditions such as high temperatures toxic gases may leak in…
Due to a manufacturing issue, the cell modules installed in the high voltage battery may be defective, which could cause an internal short circuit. A short circuit could result in…
Due to a manufacturing issue, oil may leak past the engine piston rings. If this occurs, the engine could stall causing the rear wheel to lock leading to a loss of motive power and…
Due to a manufacturing defect, the engine crankcase fastening bolts may have been overtightened. This could result in seizure of the crankshaft bearing material, abnormal noise and…
Due to a manufacturing issue, oil may leak past the engine piston rings. If this occurs, the engine could stall causing the rear wheel to lock leading to a loss of motive power and…
Due to a manufacturing defect, the axle mounting brackets may fracture. If this occurs, it could lead to a loss of vehicle stability and control whilst driving.
Due to a manufacturing defect, the right-side curtain airbag inflators may unexpectedly rupture.
Due to a manufacturing defect, the left-side curtain airbag inflators may unexpectedly rupture.
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual warnings for the brake system lights, gear selection indicators, and other critical sa…
Due to a software issue, the Instrument Panel Cluster (IPC) may fail to illuminate the visual warnings for the brake system lights, gear selection indicators, and other critical sa…
The HAVAL H7 headrest utilises a unilateral locking mechanism, where the locking pin slides downward along the headrest rod into the lock slot to secure the position. In affected v…
Due to a manufacturing defect, the left and right curtain airbag inflators may unexpectedly rupture.
The Antilock Brake System (ABS) fuses/and or fuse box holders, may have been incorrectly installed during the wiring assembly. As a result, the ABS unit may not be adequately prote…
The location of the front and side reflectors fitted to the affected trailers do not comply with the requirements of Australian Design Rule (ADR 13/00).In Addition, the side marker…
Due to a software issue in the vehicle’s Engine Control Unit (ECU), the engine may stall at low RPM resulting in a sudden loss of motive power whilst riding.
Due to a software issue in the vehicle’s Engine Control Unit (ECU), the engine may stall at low RPM resulting in a sudden loss of motive power whilst riding.
Due to a manufacturing defect, the main body wiring harness may chafe against the transmission housing and become damaged. If this occurs, it could lead to a short circuit resultin…
Due to a manufacturing defect, moisture may enter the ARB Solis lights wiring harness causing corrosion. If this occurs, it could generate excessive heat leading to a vehicle fire…
Due to a hardware defect, the high voltage battery may discharge whilst charging the vehicle. If this occurs, it could overheat leading to a vehicle fire.
Due to a software issue, the Electronic Stability Control (ESC) system may not re-activate when the vehicle exceeds 40 Km/h after the driver has manually switched off the ESC funct…
Due to a software issue, the Electronic Stability Control (ESC) system may not re-activate when the vehicle exceeds 40 Km/h after the driver has manually switched off the ESC funct…
Due to a software issue, the Electronic Stability Control (ESC) system may not re-activate when the vehicle exceeds 40 Km/h after the driver has manually switched off the ESC funct…