Every safety recall published by the Australian government, searchable and filterable.
The vehicle's wheel nuts may not have been tightened correctly, which may cause the wheels to become loose and risk falling off.
The adhesive connection of the drive shaft to the engine/transmission flange may not meet specifications. This may lead to the development of unusual noise, transmission malfunctio…
Due to improper Engine Control Module (ECM) programming, the ignition coil may overheat, creating a short circuit and blowing the fuse.
The oil pressure solenoid programming is not compliant to the required specification, which may result in decreased oil pressure.
The front trunk lid lock screws may not be tightened to the required specification.
The exhaust valve wiring may not be adequately mounted under the vehicle, and may come into contact with the exhaust. The wiring may melt the duct and then melt the wiring, which m…
Fuel may leak from the engine's high pressure fuel rail feed lines.
During assembly the tie rod may have been incorrectly mounted to the right front axle stub.
The threaded connection of the upper hood catch may not have been tensioned correctly.
Testing has shown that the passenger airbag does not meet the applicable standard. The defects relates to the balance of the trigger times between the belt tensioner and passenger…
Due to a production non-conformity, the brake line retaining clip may not be fixed correctly to the clamping fastener on the firewall.
Fuel may leak from the engine's high pressure fuel rail feed lines.
The bellows of the flexible tube (installed between the engine and diesel particulate diffuser filter) may rub on the outer section of the exhaust flex pipe by resonant vibration o…
Bolts may be loose or missing from the left-hand side steering system hub.
The gas struts that hold the back door open may not have been manufactured properly, which may allow the gas charge to leak.
The engine oil breather system may operate incorrectly, possibly resulting in an oil leak from the air intake breather tube.
The four lock nuts for fastening the airbag may have been installed incorrectly.
The oil pressure solenoid valve wiring was not manufactured to the required specifications, which may lead to engine failure.
The parking brake cable was not manufactured to the required specifications, which may result in the parking brake to fail.
If damage to the shift fork/selector sleeve/gearwheel occurs, gear changes may not be performed correctly. If gear changes cannot be performed correctly, two gears may be engaged a…
If damage to the shift fork/selector sleeve/gearwheel occurs, gear changes may not be performed correctly. If gear changes cannot be performed correctly, two gears may be engaged a…
The electric line for the power supply of the coolant pump may make contact with the engine fan, causing damage.
Due to a production fault, over time a crack in the transmissions pressure accumulator can occur.
Due to a production fault, over time a crack in the transmissions pressure accumulator can occur.
Cracks in the rubber hose of the oil cooler may allow a small amount of oil to leak.