Every safety recall published by the Australian government, searchable and filterable.
Due to incorrect manufacture, the Power Assisted Steering (PAS) cooler hose may detach from the stub pipe, causing the vehicle to leak hydraulic steering fluid.
Over time the aluminium positive crankcase ventilation (PCV) valve may fracture, allowing the engine to draw an increased amount of engine oil. This may cause excessive exhaust smo…
Vehicles have been manufactured with an Anti-lock Braking System (ABS) actuator with an oil seal that may leak brake fluid internally.
Incorrectly fastened wheel arch covers could come loose over time and potentially detach from affected vehicles.
Frequent use of the hazard lamps may cause the fuse to blow and the hazard and turn signal lamps to become inoperative.
A faulty condenser may have been fitted inside the airbag control unit.
There is potential for the 'brake pad worn' warning message to not be permanently displayed, resulting in the driver not being informed that the brake pads have worn out. The warni…
The attachment of the trim divider at the rear door windows might not meet specification.
The front passenger airbag may not have been sewn in accordance with the specifications.
The self-adjustment mechanism within the brake caliper housing may be defective, resulting in reduced or lost braking performance when applying the parking brake or service brake.
The gear position switch used may provide an inaccurate signal, which can lead to an incorrect gear being displayed in the rider display.
The outlet exhaust pipe is incorrectly positioned, which may cause heat damage to some braking system components, such as the service brake relay valve, which may melt.
Vehicles have been supplied with incorrect information in the Owner Manual in regards to the installation of ISOFIX child restraint system.
Vehicles have been supplied with incorrect information in the Owner Manual in regards to the installation of ISOFIX child restraint system.
Fuel may leak from the engine's high pressure fuel rail feed lines.
The drag link jam nut may loosen and may result in the drag link separating from the adjuster sleeve.
A cross-member at the base of the rear seat frame may have been improperly welded to the seat frame.
The down view mirror may detach from the left side door.
The engine valve may leak and may cause the engine intake manifold to melt or deform.
Fuel may leak from the engine's high pressure fuel rail feed lines.
The engine valve may leak and may cause the engine intake manifold to melt or deform.
Affected vehicles may be fitted with a Takata NADI 5-AT driver airbag inflator that could allow moisture to enter the unit and degrade the airbag propellant. If this occurs, the pr…
The gas struts that hold the back door open may be manufactured improperly, which may allow the gas charge to leak.
The static noise level exceeds the regulated maximum decibel limit.
Over time the aluminium positive crankcase ventilation (PCV) valve may fracture, allowing the engine to draw an increased amount of engine oil. This may cause excessive exhaust smo…