Every safety recall published by the Australian government, searchable and filterable.
The alternator of the affected models may experience diode thermal fatigue due to cyclical loads induced by the electro-hydraulic power steering (EHPS).
The steering wheel wire harness may become trapped between a tab on the steering wheel plastic back cover and the edge of the horn plate.
On affected Euro 5 Canter trucks the injector fuel return hose may swell and disconnect if exposed to chemicals from paint, shampoo or grease. These chemicals may be used during re…
In the event of an impact which deploys the front seat belt retractor pre-tensioner, there is a possibility that the insulation material on the inner face of the lower 'B' pillar t…
Certain vehicles under particular environmental conditions may ingest excessive levels of dust, which may block the carbon canister during a purge cycle. This could cause the fuel…
The structure of the front deck allows water intrusion onto the windshield wiper motor. Water accumulated around the wiper motor breather hole is drawn into the motor as it cools d…
Vehicles equipped with Euro 5 R-engine, might exhibit premature deterioration of the fatigue-resistance and oil-proofing of the fuel feed hose.
The Occupant Restraint Control (ORC) module on a number of vehicles may activate a diagnostic trouble code (DTC). This is due to external stimulus which disables the ORC ability to…
If a LPG vaporizer has been serviced or replaced there may be a loose electrical ground connection. This may cause an electrical arc in the LPG fuel feed hose.
The battery sensor installed in the affected vehicles may have been improperly manufactured, with gaps that could allow for moisture intrusion.
Service Action SA-07-0209 was issued to update the transmission software on a quantity of Aston Martin V8 Vantage vehicles with SportShift II transmission. The Service Action did n…
A connector in the hydraulic system for the 7-speed Auto-Shift Manual (ASM) transmission may not have sufficient support. The connector is between the pipe for the clutch fluid and…
The Tyre Pressure Monitoring System (TPMS) for the affected vehicles was calibrated incorrectly and as a result, does not illuminate the low tyre pressure warning at the required…
The starter motor 12V connection lug may be fitted incorrectly and may touch a metal component, causing a short circuit.
The start motor 12V connection lug may be fitted incorrectly and may touch a metal component causing a short circuit.
Airbag deployments in right hand drive Model X vehicles are commanded by the vehicle’s restraint control module (RCM), which requires a valid occupant classification value to deplo…
There is a possibility of debris contamination during the assembly of engine units.
The seat belt pre-tensioner, on the right hand side in the third row passenger seat may have been produced with an incorrect production parameter. The seat belt will operate as int…
The fuel return hose may leak.
The fuel return hose may leak.
The oil line clamp used on the oil cooling system on certain MY 2017 Touring model motorcycles may not have been installed properly.
On affected vehicles manufactured with a specific period, foreign particles in the coolant may lead to a blockage in the additional coolant pump and cause the pump to overheat.
During production of the dashboard panel the process of milling the “weak points or deployment points” in the passenger side of the panel has not been carried out.These points are…
Vehicles repaired or serviced between 3 December and 5 December 2016 may have had incorrect software uploaded. The upload may affect various control units and affect numerous syste…
The internal component of a non-compliant electrical relay might disrupt the starter control, damaging the relay by overheating.