Every safety recall published by the Australian government, searchable and filterable.
The seatbelt retractor mechanism could fail to restrain passengers in their seats in a rollover accident.
The top tether anchorage point at the centre position of the rear seat bench may be concealed.
Due to an improper setup of programming equipment for the Gear Shift Unit (GSU) stroke sensor, this may prevent the automated manual transmission from changing gears.
Due to a manufacturing error, the interior rear-view mirror glass may detach from the mirror housing.
The metallic components under the roof bed mattress may corrode in humid conditions.
On some RAM 1500, 2500 and 3500 Trucks, the master cylinder pushrod clip may not be secured correctly.
The engine crankshaft may have surface damage due to a manufacturing error.
The hydrostatic control unit may fail, switching the transmission from hydrostatic to manual transmission mode.
The software installed on the engine management unit (ECU) may cause premature ignition, that can result in the engine stalling and with the possibility of a fire.
Some brake booster pumps may be manufactured improperly, and may cause the brake assist function to stop operating while driving.
Some brake booster pumps may be manufactured improperly, and may cause the brake assist function to stop operating while driving.
Due to a production fault, the front seat wiring harness may be damaged.
The Front Under-Run Protection Device (FUPD) may collapse if involved in a frontal collision.The vehicle does not comply with the Australian Design Rule 'Vehicle Standard (ADR 84/0…
The Power-Train Control Module (PCM) software which controls the cylinder deactivation function may not operate correctly, and may cause an Intake Valve Rocker Arm to move out of p…
The Front Under-Run Protection Device (FUPD) may collapse if involved in a frontal collision.The vehicle does not comply with the Australian Design Rule 'Vehicle Standard (ADR 84/0…
Brake caliper mounting bolts may not provide adequate clamping force between the brake caliper and brake anchor plate.
The wire harness for the electric power steering may be damaged, resulting in the insulation on the wire harness becoming damaged over the service life of the vehicle.
The engine valve may leak and may cause the engine intake manifold to melt/deform.
The rear axle housing may have been assembled with an inclined flange and stress may be applied to the axle shafts and/or the hub bearings, resulting in failure.
The vehicle's sun visor does not have the required labelling advising consumers not to install rearward-facing child restraints in the front seat of the vehicle, and the owner's ma…
The metal bracket on the vehicle under cover may separate from the vehicle while driving.
Correct Stationary Noise Data labels were not fitted onto these motorcycles in production (as required by Australian Design Rule ADR 83).
The fuel tank ventilation system may be defective and cause pressure to build in the tank, resulting in fuel potentially spraying out of the tank when the fuel cap is opened.
The throttle control cable may break.
The plastic sleeve of the selector lever cable may not be durable throughout the service life of the vehicle. If the plastic sleeve breaks, the transmission may not change into par…