Every safety recall published by the Australian government, searchable and filterable.
During testing there was greater than expected variation in CO2 emissions between vehicles.
On certain vehicles, the windshield wiper washer jets may become inoperative when driven in freezing conditions.
Due to a software fault, the vehicle's rear external lights may malfunction in certain Sprinter vehicles, when the rotary light switch is moved to a different position in less than…
During testing there was greater than expected variation in CO2 emissions between vehicles.
In some vehicles clearance between the hood and the front brake hose may be inadequate, resulting in chafing of the front brake hose and a possible air leak. A damaged brake hose m…
Incorrectly fastened wheel arch covers could come loose over time and potentially detach from affected vehicles.
Part of the vehicle's engine harness may come into contact with the metal link pipe heatshield and chafe, causing damage to wires within the engine harness bundle.
Due to an error in the active brake assist software, one of the radar sensor control units may fail.
Due to inadequate welding strength, the front right side suspension lower control arm may fail at one of the weld joints.
Due to a factory fault, the full LED headlights setting may not be assembled correctly.
Due to a manufacturing fault, the Electronic Control Unit (ECU) airbag system may be defective and not activate.
The current layout of the Bowden cable installed within the driver and passenger doors creates tension on the door lock and may cause the cable retainer to break, preventing the do…
The air conditioning systems drain hoses may not have been installed correctly, and may result in condensation leaking into the vehicle's interior.
In some MY2019 Jeep Cherokee KL vehicles there may be a loss of communication between an acceleration sensor and the occupant restraint controller (ORC).
Due to a manufacturing defect, there is an abnormality in the fuel vapour separator component located between the evaporative emissions canister and the fuel tank.
Potential non-conformity of the air bag and the seat belt pretensioners Electronic Control Unit (ECU) could lead to power supply failure, causing the vehicles air bags and/or the s…
Wheel arch covers may be incorrectly fastened on some vehicles and may loosen over time.
The tow bar may fully or partially separate from the mounting points during towing.
If the vehicle's external front indicator light stops operating over time, the driver may not receive the corresponding warning.
Due to a manufacturing fault, the seat belt mounting bolt may fail.
Due to a manufacturing fault, the seat belt mounting bolt may fail.
Some vehicles may experience a stuck clutch, resulting in a transmission-commanded shift to neutral.
On short wheelbase T6 vehicles with an electric rear lid and electric sliding doors, water may get into the vehicle interior and run onto the control unit for the electric doors.
On some Alfa Romeo Giulia MY2017-2019 and Alfa Romeo Stelvio MY2017-2019, the instrument panel shows more fuel than what is actually present in the fuel tank.
Due to an error in the Frontal Collision-Avoidance Assist (FCA) software, the braking assist function may fail when the vehicle approaches a stationary vehicle.