Every safety recall published by the Australian government, searchable and filterable.
During assembly the vehicles may not have had the front brake tube fitted correctly. The tube may come in contact with the exhaust system and the braking performance could be compr…
Due to a software error, the electric power steering may become unavailable sporadically.If this occurs, greater force will then be required to turn the steering wheel. Power steer…
A rear seat backrest may be fitted on which the mounting for the head restraint is not correctly welded to the outer backrest frame for the rear seat.
During refueling, if the fuel nozzle is turned or not inserted incorrectly into the filler tube, the liquid fuel can leak into the fuel tank system. Liquid fuel can be sucked into…
A concern may exist with the software in the vehicles Audio 20 control unit that will affect the automatic occupant detection for the front passenger seat in the vehicles effected.
There is the possibility for engine oil to leak from one of the hydraulic tensioner's on each of the cylinder heads on the engine.
The fuel tank may be compromised due to damage incurred by a manufacturing process.
The vehicles are equipped with a Continuously Variable Transmission (CVT) assembly that uses a torque converter to transfer engine power from the engine to the transmission.There i…
There is the potential for a failure of the delivery oil line fitting on the engine oil cooler resulting in an oil leak from the oil cooler component.
Increased electrical resistance in a component within the Electric Power Steering system may result in a loss of power steering assistance.
Due to improper routing, the rear brake hose and rear wheel rotation sensor lead may touch the rear tyre.
The Automatic Clutch Unit (ACU) has two motors that operate the clutch. An ACU motor may not operate correctly, if wear occurs on the internal brush. If one motor fails, the other…
In certain vehicles, the Owner's Manual supplied contains an error relating to the description of the rear door child lock function where the locked and unlocked positions are inco…
In certain vehicles, the speed sensor is manufactured using materials that have different thermal expansion properties. When the temperature increases, the materials inside the sen…
The vehicle is equipped with a stop-start system that automatically stops and restarts the engine when the vehicle is stationary (e.g. at a stop light). Due to improper programming…
Airbag inflator: As it gets older, a combination of high temperatures and humidity can cause the airbag inflator propellant to degrade. If an affected vehicle is involved in a coll…
If a child seat is installed in the front passenger seat, it is possible that the front passenger airbag might not be switched off as intended and could be triggered in the event o…
In some vehicles, the locking mechanism on the rear sliding door may be defective and unable to hold the door open.When the vehicle is at a forward incline, the holding mechanism m…
In certain vehicles, the Owner's Manual supplied may not contain all relevant information required by the mandatory standard. In other vehicles, the Owner's Manual may not have bee…
A diesel fuel line may be incorrectly routed, causing chafing against nearby components.
In select vehicles, the supplied jack‘s label does not comply with the mandatory standard ‘Trade Practices Act 1974 Consumer Protection Notice No. 1 of 2010 Consumer Product Safety…
On some RAM 2500 and RAM 3500 vehicles, the heater hose may not be securely mounted, which will address a possible friction point, causing wear to the brake pipe assembly.
The outer section of the front grille air deflectors could detach partially or entirely from the inner section of vehicle. Clips could slowly detach due to the wind loads that aris…
The driving range indicator may provide inaccurate information about the distance that may be driven before refuelling, due to a programming error in the Combination Meter Display…
Potential failure of the inner wall of the shock absorber may cause fragments to adhere to the piston ring.