Every safety recall published by the Australian government, searchable and filterable.
If the driver’s seat base has been replaced for any reason, the seat position sensor may be inoperative. If the vehicle has an inoperative seat position sensor, has the driver’s se…
Due to electrical 'noise', the vehicle may suddenly switch to fail-safe EV mode while cruising at highway speed, causing the internal combustion engine to shut off with visual and…
A certain number of Western Star model vehicles have been fitted with a supplementary ABS trailer receptacle which does not have the required circuit current rating as outlined in…
It is possible that the front drive shafts fitted to affected vehicles may not meet specification and could fail during initial acceleration and take-off.
On affected vehicles there is insufficient strength in the material which makes-up the air compressor cylinder head gasket. Vibration caused by the air compressor piston’s back and…
Due to a possible non-conformity in the production process of the driver side airbag module, the airbag may deploy abnormally.
Certain vehicles may have been fitted with bolts in the steering system which are not of the correct specification. Should the bolts fail the attachment of the steering linkages to…
The ignition switch wire may rub on the underside of the fuel tank and cause a possible electrical short, damaging the ignition switch.
The affected vehicles have CVT programming that uses high hydraulic pressure which may subject the drive pulley shaft to high stress during operation. The higher stresses combined…
Software issues in the BMS-E engine management ECU, and the possibility of an air leak due to a loose intake stub, may cause the engine to stall.
The fuse for the starter motor may blow in a stop/start sequence.
Incorrect fitment of brake tubing or seal ring on the brake booster system.
A damaged seal may have been fitted to the secondary bulkhead in the engine compartment; this seal may come loose and partially fall into the engine compartment.
Loss of power to the MDPS will increase steering effort. If the defect occurs, the electronic power steering (EPS) lamp will be illuminated on the instrument panel.
In the event of a crash the inflatable Curtains (IC) may not inflate fully as intended for passengers in the third row.
These motorcycles may have a poor seal at the fuel pump inlet. This could allow an interruption to the fuel supply under acceleration at low fuel levels, possibly before the low fu…
The handle crown on some YZF-R3A models may crack under normal riding conditions due to a casting problem that occurred during the manufacturing process.
The front axle screw/nuts may have been incorrectly torqued, which can lead to the screws/nuts holding the front axle to become loose.
The power liftgate control module on your vehicle may experience a corrosion induced high resistance short circuit in the power liftgate control module electrical connector(s).
The wiring harness malfunction may potentially lead to a short circuit within the vehicle’s electrical systems.
Some customers have reported the inability to secure the door in the closed position, either on the primary or secondary latch. In addition, there have been reports that one of the…
The engine beauty cover on some vehicles may detach from the engine and come in contact with the catalytic converter.
Fuses within the interior fuse box may become loose. This may result in the failure of various systems, potentially causing incorrect deployment of the air bags.
The four mounting bolts used to secure the Bull Bar may not meet specification and could fracture.
Some vehicles have incorrectly crimped wiring in the plug for the seatbelt pretensioners.