Every safety recall published by the Australian government, searchable and filterable.
A number of clamp sleeves for the draglink of the first axle have been found to break during fitting. This failure has been caused by excessive torquing of the nuts.
BMW Motorrad has noticed that in some cases an incorrect fault entry has been programmed into the fault memory of the Digital Motor Electronics System (DME).
The bolts that fasten the drive plate to the torque converter may become loose or detach due to insufficient fastening on Automatic Transmission (AT) or CVT.
There is a possibility of improper welding on front propeller shafts manufactured prior to Friday, 25 November 2011, which may result in the weld failing. If the weld fails, the f…
A limited number of Amarok vehicles had fuel pipes incorrectly positioned during production. This defect, combined with vibrations in the engine bay, may lead to chafing or cracks…
There is a possibility of improper welding on Front Suspension Lower Control Arms (LCA) produced prior to Friday, 11 May 2012 which may result in the weld failing.
A fuse that protects some of the exterior vehicle lights may blow due to thermal overload.
Due to electrolysis in the gearbox, the sulphur constituents in the synthetic oil can separate off. These accumulations settle between the conductor paths of the electronics in the…
Yamaha has determined that the resistance in the wire harness between the APS,TPS and ECU may increase due to a manufacturing defect in the wire harness at the time of production.…
The bolts that fasten the drive plate to the torque converter may become loose or detach due to insufficient fastening on Automatic Transmission (AT) or CVT.
Due to insufficient weld strength the clutch master cylinder may break whilst it is operating. In this case the fluid will leak and the clutch release function will cease to operat…
Due to a disruption of computer communications and loose alternator ground wires, the affected vehicles may experience random or failed illumination of dashboard warning lights and…
The front brake cable may break. If this occurs the front brake becomes inoperable, in addition, the parking brake no longer functions.
The engines contain valve springs that could have been produced with corrosive pitting on the surface of the spring. The corrosive pitting could lead to fatigue cracks, which could…
The connection between the fuel return pipes and the injectors may have been damaged during assembly in the factory.
Some of these motorcycles may exhibit a condition in which the hydraulic clutch system may lose the ability to generate enough lift to disengage.
Some of these motorcycles may exhibit a condition in which the hydraulic clutch system may lose the ability to generate enough lift to disengage.
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…
An incorrect specification stop lamp switch was installed in some Nissan C12 Pulsar vehicles fitted with CVT automatic transmission. In extremely rare cases, the rear stop lamps ma…
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…
The satellite sensor for the side curtain airbag in the B-Pillar may not have been installed correctly in some Nissan B17 Pulsar, C12 Pulsar and N17 Almera vehicles. In extremely r…
The rear seat centre child restraint anchor point is not accessible due to an incorrect seat backrest trim fitted during production.
The daytime running lamps may illuminate at low intensity output, instead of the desired high intensity output, during certain driving conditions.
Over time the vacuum pump may fail completely due to a lack of lubrication. As a result, the power brake booster unit is not supplied with sufficient vacuum force, which reduces th…
It has been found on a very small number of vehicles that the driver's seatbelt stalk mounting eyelet flange may have been crimped onto the seatbelt stalk cable at the wrong angle.