Every safety recall published by the Australian government, searchable and filterable.
Due to a software issue, the Hybrid Powertrain Control Module (HPCM) may inadvertently shift to neutral while driving, come to a stop and automatically shifting to “Park”. If this…
Due to a manufacturing defect, the oil filter housing may not meet specifications and could crack over time. If this occurs, oil could leak into the engine bay and accumulate in th…
Due to a manufacturing defect, the oil filter housing may not meet specifications and could crack over time. If this occurs, oil could leak into the engine bay and accumulate in th…
Due to improper routing during assembly, the wiring harness leading to the vehicle’s horn may become damaged or disconnected. As a result, when the steering is operated at its limi…
Due to a manufacturing defect, there is a possibility of engine machining debris contamination within the engine. This could lead to potential engine knocking, rough running and/or…
The hood latch striker rivet studs may have been assembled with insufficient deformation. If this occurs, at high speeds small gaps between the hood and front bumper could develop.…
The Exhaust Gas Recirculation (EGR) valve sensor may have been exposed to soldering flux contamination during manufacture. This could cause a short circuit within the sensor result…
Due to a manufacturing issue, the cell modules installed in the high voltage battery may be defective. A short circuit could cause a thermal overload and result in a vehicle fire o…
Due to a software issue within the Power Steering Control Module (PSCM) the Lane Change Warning Assist (LCWA) feature may not operate as intended. As a result, there is an increase…
Due to a manufacturing defect, the High-Pressure Fuel pump may cause over-pressurisation in the fuel system. This could impair the fuel supply to the engine and result in warning l…
Due to a manufacturing issue, the cell modules installed in the high voltage battery may be defective. A short circuit could cause a thermal overload and result in a vehicle fire o…
Due to a software issue, the passenger side folding door control unit may have been overwritten with incorrect parameters. As a result, if an obstacle is detected during automatic…
Due to a calibration issue within the Vehicle Control Module (VCM), when driving at low speeds the vehicle may falsely detect reflective objects such as metal walls, barriers or si…
Due to a software error, the infotainment unit screen may enter a test mode during start-up of the vehicle. This may prevent key information such as the vehicle's speed from being…
Due to a manufacturing defect, the side curtain airbag may inflate without warning.
Due to a manufacturing defect, the sealing of the high-voltage battery housing may be insufficient, allowing moisture to enter into the battery compartment. This may cause the vehi…
Due to a manufacturing defect, the driver’s side B-pillar may not have been welded to the required specification. As a result, the reinforcement in pillar may become loose over tim…
Due to a manufacturing defect, the high-voltage battery housing in affected vehicles have an insulation fault. This may cause the vehicle's battery to turn off when driving resulti…
The brake lamp switch assembly may have been installed incorrectly, if the hill starting assist device (EZGO) is activated, there may be a large time lag until the brake lamp light…
Due to a software issue within the Body Control Module, the parking lamps and number plate lamp may not illuminate when the vehicle is travelling below the speed of 10 kilometres p…
Due to a manufacturing defect, over time and under certain conditions friction and excessive movement in the steering gear could result in a loss of steering control.
Due to a manufacturing issue, the cell modules installed in the high voltage battery may be defective. A short circuit could cause a thermal overload and result in a vehicle fire o…
Due to a manufacturing defect, the passenger airbag may tear during deployment. This could cause hot gases to escape from the airbag at high speed and result in insufficient protec…
Due to software settings, if a vehicle occupant places an obstruction such as a body part between the frame and glass when the sunroof is closing, it may not reverse until signific…
Due to a manufacturing defect, the power liftgate module (PLGM) may fail due to an electrical short circuit. This may result in a vehicle fire with the ignition turned on or off.