Every safety recall published by the Australian government, searchable and filterable.
If a LPG vaporizer has been serviced or replaced there may be a loose electrical ground connection. This may cause an electrical arc in the LPG fuel feed hose.
The wires serving the hazard warning lamps may become damaged during normal steering action.
The bushing or the universal joint spider may detach from its seat.In addition, a tear may happen in the weld between the propeller shaft and the propeller shaft head as this weld…
Defective steering shafts may have been installed in certain vehicles. These steering shafts may have insufficient tooth flank depth in the serrations for the required power transm…
The fixed fork tube can suffer preliminary damage when unusual incidents with momentary high stress occur.
In specific Econic 956 models used as refuse vehicles, the steel cables of the seat belt anchor, installed between the raised centre seat and the co-driver's seat, may be deformed…
If the vehicle is in a frontal collision severe enough to deploy the front airbags, the airbags may deploy with too much force, due to the possibility of over set parameters.
The front passenger airbag in affected vehicles may not meet specifications. In the event of an accident triggering a front passenger airbag, it may not deploy as designed. As a re…
The structural longevity of the Draw-Bar is uncertain on some caravan models constructed with an aluminium chassis due to the absence of strengthening gussets.
The Active Brake Assist (ABA) and Adaptive Cruise Control (ACC+) systems may become unavailable on specific vehicles due to an internal defect of the radar sensor.Before the failur…
The gas generator of some front seat belt tensioners may have been incorrectly crimped onto the actuator pipe of the belt tensioner.
The battery sensor installed in the affected vehicles may have been improperly manufactured, with gaps that could allow for moisture intrusion.
On affected vehicles and only when an emergency braking function is initiated via the Electro-mechanical Parking Brake (EPB) button, the brake lights at the rear of the vehicle fai…
The bolts securing the lower steering joint may not have been torqued correctly, over time this may result in wear to the steering joint causing a reduction of steering control. In…
Service Action SA-07-0209 was issued to update the transmission software on a quantity of Aston Martin V8 Vantage vehicles with SportShift II transmission. The Service Action did n…
A connector in the hydraulic system for the 7-speed Auto-Shift Manual (ASM) transmission may not have sufficient support. The connector is between the pipe for the clutch fluid and…
The Tyre Pressure Monitoring System (TPMS) for the affected vehicles was calibrated incorrectly and as a result, does not illuminate the low tyre pressure warning at the required…
The starter motor 12V connection lug may be fitted incorrectly and may touch a metal component, causing a short circuit.
The start motor 12V connection lug may be fitted incorrectly and may touch a metal component causing a short circuit.
The weld seam on the steering column bracket is incomplete.
The connection on the brake booster vacuum hose may break, resulting in a lack of power assistance to the braking system. This may require additional pedal force to stop the vehicl…
The turn signal speed doesn't change when a globe is not working.
There is a risk of insufficient weld penetration and/or overgrinding of the weld on the suspension trailing arm elbow resulting in reduced material thickness.
The front bumper bar lower trim finisher may not have been properly secured.
1. The current Head Light Control Unit (HLU) software may cause the LED headlight to reboot while in operation.2. The instrument dashboard may lose information or not display all i…