Every safety recall published by the Australian government, searchable and filterable.
Defect in the parking brake switch that could fail to alert the driver when the park brake is still engaged.
The automatic transmission output flange may develop wear due to torque fluctuation of the engine and as a result of frequent acceleration and deceleration.
The airbag initiators within the side airbag modules may contain an incorrect chemical mixture.
The airbag initiators within the side airbag modules may contain an incorrect chemical mixture.
The screws retaining the right fixed baring stud, fixing the rear wheel swinging arm may come loose from the frame.
There is a possibility that an incorrect specification airbag assembly was installed during the vehicle assembly process.
On affected vehicles the screw/bolt in the range group catch bolts may come loose.
In specific vehicles the windscreen wiper motor venting device may be non-compliant. This may allow water to enter the wiper motor, creating internal corrosion and locking up the m…
The airbag initiators within the side airbag modules of certain Ranger and Everest vehicles may contain an incorrect chemical mixture.
In specific vehicles the windscreen wiper motor venting device may be non-compliant. This may allow water to enter the wiper motor, creating internal corrosion and locking up the m…
The alternator of the affected models may experience diode thermal fatigue due to cyclical loads induced by the electro-hydraulic power steering (EHPS).
The steering wheel wire harness may become trapped between a tab on the steering wheel plastic back cover and the edge of the horn plate.
On affected Euro 5 Canter trucks the injector fuel return hose may swell and disconnect if exposed to chemicals from paint, shampoo or grease. These chemicals may be used during re…
In certain Isuzu F series vehicles, the lock plate of the front RH spring shackle pin was not crimped to the correct specification during the vehicle assembly process. If the vehic…
The air conditioning drainage hose, that is used to transfer condensation water generated by the air conditioning unit out of the vehicle, may not have been properly attached.
Moisture may penetrate the electric power steering control unit. This may interfere with signal transmission in the control unit and cause the steering power assistance to fail.
In the event of an impact which deploys the front seat belt retractor pre-tensioner, there is a possibility that the insulation material on the inner face of the lower 'B' pillar t…
An incorrect seat wiring harness layout which can cause the seat wiring harness to rub against metal points on the seat/seat frame assembly.
Certain vehicles under particular environmental conditions may ingest excessive levels of dust, which may block the carbon canister during a purge cycle. This could cause the fuel…
The tail/brake light globe socket assembly may become loose during normal operation, allowing the light bulb to fall out.
The secondary bonnet latch cable has a risk of being corroded. If this occurs, it may fail to engage the secondary latch.
The structure of the front deck allows water intrusion onto the windshield wiper motor. Water accumulated around the wiper motor breather hole is drawn into the motor as it cools d…
Vehicles equipped with Euro 5 R-engine, might exhibit premature deterioration of the fatigue-resistance and oil-proofing of the fuel feed hose.
The front brake pipe from the caliper to the flexible brake hose is showing signs of a chafe condition.This has occurred on some Defenders that have been subject to an earlier reca…
The Occupant Restraint Control (ORC) module on a number of vehicles may activate a diagnostic trouble code (DTC). This is due to external stimulus which disables the ORC ability to…