Every safety recall published by the Australian government, searchable and filterable.
Rear air suspension bolt could break and come off due to hydrogen embrittlement.
The front side lights, when used as parking lamps, will extinguish in error after approximately 5 minutes.
The front brake flexible hoses may rupture.
Due to a manufacturing process error, the wheel hub components may not have been tightened to specification.
The compressed air system vent valve may become blocked. A blocked vent valve will result in a pressure increase in the air dryer which may result in the top of the air dryer detac…
The steering wheel boss, which is connected to the steering column, may not have the appropriate strength. If a load is applied to the steering wheel which is higher than the load…
Due to insufficient design of the PVC tube holding the flasher relay, the turn signals may not operate.
The belt tensioner that drives the engine accessories has been manufactured incorrectly. This may cause the belt to come off and warning lamps to illuminate.
The belt tensioner that drives the engine accessories has been manufactured incorrectly. This may cause the belt to come off and warning lamps to illuminate.
Due to a manufacturing issue with the fuel pump assembly there may be insufficient clearance between the fuel pump body and impeller, which can interfere with normal fuel pump oper…
The seal ring between the timing chain tensioner and the engine may leak oil.
On certain 2012MY 'Dyna and Softail' model motorcycles, the front brake master cylinders may experience corrosion in the threads for the brake line banjo bolt.
On certain 2012MY 'Dyna and Softail' model motorcycles, the front brake master cylinders may experience corrosion in the threads for the brake line banjo bolt.
Volkswagen AG has established that on Crafter vehicles of a limited production period, the earth ring of the damper weight on the propshaft can loosen.
Sections of pipe delivering brake fluid from the Hydraulic Brake Control Modulator to the left-hand and right-hand front brake calipers can fracture resulting in a brake fluid leak…
Some of the above vehicles may experience the diesel fuel heater electrical connector to overheat and cause a fuel leak.
Some of the above vehicles may experience the Occupant Resistant Control (ORC) module developing an internal fault. A coating on the ORC module printed circuit boards may have been…
There are a small number of motorcycles, which have been assembled with an incorrect size gearbox output shaft.
Sections of hose delivering brake fluid from the Hydraulic Brake Control Modulator to the left-hand and right-hand front Brake Calipers may have been twisted during vehicle assembl…
On all affected vehicles faulty signals can be generated in the airbag control unit because of a fault in the production of an internal acceleration sensor.
The fuel tube and fuel vapour tube do not have adequate corrosion resistant protective coating.
After prolonged steering operation, the Front Sub-Wiring Harness may crack causing loss of power to the main iginition switch. Should this occur the engine may cut out and be unabl…
Damage to the insulation of the electrical harness that controls the seat heater can lead to a component failure in the electronic control module of the seat heater mat.In a vehicl…
The universal joint bolt on the steering column has been incorrectly tightened.
The side stand pivot bolts may fracture. This may cause the side stand to become unstable.