Every safety recall published by the Australian government, searchable and filterable.
The steering box cover has an improper shape. This may affect the sealing of the cover, possibly allowing water leakage, which may cause rusting and then wear.
Due to inappropriate installation of the switch sleeve in the brake booster, the tip of the switch sleeve may break.
Due to poor conductivity caused by the presence of an insulating material, the brake lamp switch may not operate correctly, and in some vehicles it may also prevent the gear shift…
Due to inappropriate material of the ancillary equipment V ribbed belt on the engine, the resin pulley may wear unevenly. The belt can be damaged causing it to come off.
Prolonged use at full throttle may result in high temperature exhaust gas inside the air induction pipe.
The curtain airbag, seat belt pre-tensioner and side impact sensor circuits have been incorrectly orientated in the main wiring harness.
Water may travel along the heated power mirror wiring harness and into the heated power mirror electrical connector. This can cause corrosion inside the heated mirror connector and…
The fuel pressure sensor of some vehicles may be insufficiently tightened to the fuel rail, and may loosen gradually due to heat and vibration of the engine. In some cases, fuel le…
Due to an incorrectly programmed setting, the lamp-outage detection for the front turn signals does not function correctly.
The front brake hoses may be fitted incorrectly and the rear brake retaining clips may be the incorrect clips.
The glow plug control module that aids cold engine start up can be adversely affected by wet conditions due to its location, low in the engine compartment
Due to an issue with the assembly process, certain underbody brake pipe unions may not be to the correct torque specification.
The Frequency Operated Button Ignition Key (FOBIK) may stick between the 'START' and 'RUN' position. This may result in the loss of certain electrical features. For example the de…
The Steering Column Control Module may experience electrical interference (static) in the SCCM printed circuit board communication circuit. This unintended electrical interference…
The balancer weight gear and the balancer shaft drive gear have been found to be manufactured from an out of specification material.
Some Jeep Grand Cherokee vehicles may experience a failure in the Fuel Pump relay within the Totally Integrated Power Module – 7 (“TIPM-7”).
Engine oil leaks have occurred from certain oil cooler hoses in a small number of 2ZZ powertrain Elise, Exige and 2-Eleven vehicles and 2GR powertrain Evora vehicles manufactured b…
The driver side airbag inflator may have been incorrectly assembled.
A possible malfunction of the solid state circuitry may occur, which in rare cases causes a fuel injector to malfunction, which in turn causes the engine to lose power.
Due to a change in production process, the threaded connection between the piston rod and screw cap may not be sufficiently tight. If the piston rod detaches from the screw cap, th…
Due to a change in production process, the threaded connection between the piston rod and screw cap may not be sufficiently tight. If the piston rod detaches from the screw cap, th…
Introduction of Roll Stability Advantage (RSA) on metroliners required brake lights to come on with an RSA event.
There is a possibility that the lock bracket for the front cargo area may open unintentionally.
The front airbags may not inflate correctly in the event of an accident.
Due to issues with the assembly process, certain fixings may become loose. This may result in the Front End Accessory Drive belt slipping or falling off, the Power Assisted Steerin…