Every safety recall published by the Australian government, searchable and filterable.
The trailing arm of the rear torsion crank axle can break as a result of damage caused from impact to the vehicle such as a rear-end collision, or impact with the edge of a curb.
BMW Motorrad has ascertained that the screws securing the side-stand pivot mount can work loose. Due to a process fault, the part of the frame where the side-stand pivot mount sits…
The vehicle Weight Certification label has the incorrect value for Gross Vehicle Weight Ratings (GVWR).
The battery lead may be pinched between the seat base and the seat bracket. Over time the insulation of the battery wire lead may be worn away.
There is a possibility that the sealing property of the gasket between the fuel pressure sensor and the fuel delivery pipe could become degraded over time and may result in a fuel…
A defect has been identified in the installation of the electric braking system.
On affected vehicles, when the Hill Start Assist function is switched-on, the warning buzzer will not operate and warn the driver if the key is removed from the ignition switch.
Due to incorrect setting of the angle detection sensor, it is possible the seatbelt will not be able to extend when the vehicle is parked on a downhill slope.
The retractor lock sensing mechanism inside the third row seat belts may not meet a particular requirement of the Australian Design Rules relating to the locking of the safety belt…
A wear condition in the ignition key cylinder actuator trigger may allow the vehicle starter motor to crank the engine if the key is left inside the ignition key cylinder and in th…
Certain vehicles may experience an unintended change in ignition switch position while driving.
The steering coupling lock may not have been correctly engaged.
Bearing surface on some steering mitre gears may fail prematurely. The steering mitre gear supplier has now enhanced the bearing design for greater durability.
Due to a programming error, the Powertrain Control Module (PCM) may fail to provide an adequate supply of electric power to the fuel pump following i-Stop operation. This may cause…
Under certain circumstances the left hand side drive chain adjuster may deform and move forward, causing the drive chain to make noise or fall off the sprockets and possibly damage…
The end cap on the right-hand fuel delivery pipe in the engine may have been insufficiently welded, in this condition, fuel could leak from the fuel delivery pipe.
The ABS pipes may have been fitted incorrectly.
Internal wiring may be fitted in a manner that could affect the operation of the driver’s side airbag if deployed.
Insufficient emergency exit stickers were fitted, and passenger door emergency release valve was not in a conspicuous location.
Due to a software error, the traction motor inverter may function incorrectly and the inverter system may shut down.
Due to a software issue, the vehicle may gradually accelerate regardless of accelerator pedal action. However, the driver can decelerate the vehicle as normal by applying the brak…
Due to a casting issue, there may be a crack in the automatic transmission case of some vehicles.
The front retro reflector is not within the height specified in VSB1.
The vehicle may illuminate both the low and high beam headlamp elements when the high beam mode is selected. The headlamps will then draw current in excess of the design specifica…
When the handlebars are turned from left to right the headlight lead wire may become stretched due to the insufficient length of the headlight lead wire. With repetition, the headl…