Every safety recall published by the Australian government, searchable and filterable.
The license plate holder subframe may develop cracks over time.
In the subject vehicles, the bolts and nuts fixing the centre bearing support bracket of the propeller shaft have been tightened to the incorrect torque.
These motorcycle models may develop a tear in the primary cup (seal) of their Hydraulic Clutch Master Cylinder piston.
These motorcycle models may develop a tear in the primary cup (seal) of their Hydraulic Clutch Master Cylinder piston.
The front suspension arm fixing bolts may break.
Due to a wiring concern the heater shutoff valve may overheat.
The rear suspension shock absorbers on affected vehicles may break at one of the shock absorber attachment points.
The axles may crack, either around the trailing arm attachment to the beam, or at the welds attaching the booster and cam brackets to the axle beam.
1. Low Exterior Lighting visibility2. Rear Bumper mounted too high.3. King Pin and Skid Plate may not have required markings.4. Braking System may not be of the correct configurati…
Engine oil may enter the brake servo via the vacuum lines. If this should happen, the diaphragm in the brake servo can rupture, causing the brake servo to fail.
The fastening bolts on the water pump pulley may not have the correct tension, and the bolts may loosen. If the vehicle continues to be driven the belt may come off, causing the wa…
The fastening bolts on the water pump pulley may not have the correct tension, and the bolts may loosen. If the vehicle continues to be driven the belt may come off, causing the wa…
The rear turn lamp outage detection system may not work in some vehicles.
On affected vehicles, there is the possibility that their DUONIC transmissions may experience various shift issues due to contamination of the transmission’s hydraulic system. As a…
Some issue were identified in the 5M/T Selector Lever Bell Crank assembly. This may result in disengagement of the Select Lever Pin when shifting to the Reverse or 5th gear positio…
The front seat safety belt pretensioners in some vehicles may not lock the cable during pretensioner deployment.
Retaining bolts for the pivot pins may not be fitted.
The threaded end of the bolt installed on the air conditioner condenser bracket faces the slit of the corrugated tube of the wire harness and under certain operating conditions, su…
Due to inappropriate structure of the base for the lighting switch platform, a crack may develop in the soldering in the printed circuit board between the base and the platform cau…
Due to inappropriate structure of the base for the lighting switch platform, a crack may develop in the soldering in the printed circuit board between the base and the platform cau…
Due to inappropriate structure of the base for the lighting switch platform, a crack may develop in the soldering in the printed circuit board between the base and the platform cau…
Over time, the Automatic Tensioning System (ATS) cable within the safety belt retractors of certain vehicles may break, and the seat belt may not retract.
Under certain conditions an internal short circuit in the cooling fan module can lead to a failure and combustion of the external cable insulation. Secondary short circuits can the…
Some customers have reported oil leaks from end of the front axle case. In more severe cases customers have reported that the wheel hub assembly and suspension have collapsed up in…
The material used in the nut for 2nd row middle seatbelt anchor point may not meet the specification required by the engineering drawing and design. In addition, excessive impuriti…