Every safety recall published by the Australian government, searchable and filterable.
The sunroof glass outer frame adhesive may become weak due to inappropriate resin material. As a result the sunroof glass may detach from the outer frame when driving.
All vehicles are subject to condition a) whilst only some vehicles are subject to condition b)a) Improper sealing of parking brake caliper may allow water entry, causing rust on th…
The propellant mix of certain front seat belt tensioner squibs may not meet the specifications.
The piston component material made of PPS (polyphenylene sulphide) located in handbrake master cylinder (front brake), may crack.
On the affected model motorcycles, if the brake fluid is not flushed for a prolonged period of time beyond the 2 year schedule specified in the Owner’s Manual and Service Manual, a…
On some vehicles, the shape of the teeth on the parking brake sector gear may not meet specification.
The piston component material located in the hand brake master cylinder (front brake) may crack or become damaged.Should that occur it can adversely affect front brake function or…
A manufacturing defect exists in a batch of the BREMBO front brake master cylinder component installed on a series of F4 RR and F4 RC motorcycle models.
On certain Polo vehicles of a limited production period, the welding on the towing eye in the vehicle tool kit may fail. When in use, the towing eye may tear as a result of forces…
The trunk jumper harness used on Roadmaster models was manufactured without silicone plugs that are intended to keep water out of the unused connector terminals. This may allow wat…
Part of the ABS system pipe-work may contact or rub against other parts of the engine.
The virtual display instrument cluster goes blank intermittently. The instrument cluster will not display anything during this time, but will reset while driving.
The virtual display instrument cluster goes blank intermittently. The instrument cluster will not display anything during this time, but will reset while driving.
Front brake master cylinders on motorcycles may not perform as expected under extreme braking.
A clip fitted incorrectly during production may damage the power steering return hose. Hydraulic fluid could be discharged and a loss of power steering assistance would be experien…
Part of the ABS system pipe-work may contact or rub against other parts of the engine.
A communication error between the Engine Control Module (ECM) software and the Transmission Control Module (TCM) can cause the transmission park pawl to be held out. When the trans…
There may be a program error within the Electronic Control Unit (ECU) of the fuel injection system.
A possible non-compliance on some vehicles of the fuel pipes positioned near an aerodynamic shield that could generate friction between the pipe and shield eventually causing a fue…
The retaining rings of the wheel bearings on the front axle may not be correctly engaged and if so, these may drift.
The rear centre seat position of the MG6 PLUS is not fitted with a Child Restraint Anchorage as required by Australian Design Rule 34/02.
Due to a manufacturing issue, the vacuum hose to the brake booster may become weak over time resulting in the potential for the hose to collapse when vacuum is applied. This could…
Due to insufficient bolt torque, the nudge bar roll hoop fixing bolts may come loose causing the roll hoop to rattle and in rare instances, may detach from the vehicle.
A fault in the manufacturing process for the rear hub carriers has caused a discrepancy in the material hardness. As the durability of the affected hub carriers cannot be assured,…
Certain Volkswagen Passat, Golf and Arteon models of a limited production period may have had the rear wheel bearing housing manufactured with an insufficient case hardening.