Every safety recall published by the Australian government, searchable and filterable.
Due to manufacturing defect, the bonnet latch assembly may not detect when it is opened by the driver and therefore fail to warn the driver of "open bonnet". If the vehicle is driv…
Due to a manufacturing defect, brake fluid may leak into the Antilock Brake System (ABS) control module. This could cause an electrical short circuit leading to a vehicle engine co…
The rear tyres within this production range may not meet manufacturing specifications and could develop cracking or deformation of the tyre tread. As a result, the tyre tread could…
Due to a software issue, the engine may generate more soot than intended which could cause the vehicle to trigger more frequent regenerations of Diesel Particulate Filter (DPF). Th…
The sealing washers used in the rear brake lines may not meet manufacturing specifications allowing air to enter the rear brake system. As a result, it could lead to a loss of brak…
This recall has been updated for expansion of VINs.Some vehicles may have been converted after production with steering wheel variants containing a faulty Takata inflator. As a re…
Some vehicles may have been converted after production with steering wheel variants containing a faulty Takata inflator. As a result, the driver's airbag inflator may rupture in t…
Due to a manufacturing defect, moisture may enter into the Printed Circuit Board (PCB) in the Hydraulic Clutch Actuator (HCA). This could cause an electrical short circuit and resu…
Due to a manufacturing issue, the elbow fitting from the rear spring brake valve to the forward drive axle may not have been tightened to the sufficient torque and could become loo…
Due to a manufacturing issue, the Pilot Assist System may not operate as intended and fail to alert the driver if the steering wheel is not being held.
Due to a manufacturing defect, the wheel lug nuts may not have been tightened sufficiently and could become loose. As a result, the wheel may detach from the brush chipper whilst b…
The adjusting rod used to operate the vehicle jack is of incorrect specification and may not function as intended.
Due to a manufacturing defect, the front brake hoses may be defective. This may lead to a brake fluid leak resulting in a reduction in braking performance.
The mounting bolts and nuts that are used to secure the axle assembly to the frame of the brush chipper may not have been tightened correctly. If the axle mounting bolts loosen, th…
Due to a software issue with the Anti-Lock Brake System (ABS), the Electronic Stability Control (ESC) may fail. This may result in a loss of vehicle control.
Due to a manufacturing issue, a retaining screw between the vehicle’s electrical wiring and the fuse box located in the front passenger footwell may not have been tightened suffici…
Due to a software issue, the Adaptive Cruise Control (ACC) function may not operate as intended. This may cause the vehicle to exceed the maximum speed limit of 100 km per hour if…
Due to an issue with driver seat occupancy switch, the instrument cluster may fail to illuminate the visual and audible seat belt warnings in certain conditions as required by the…
Due to operation of the seat back rest, the driver and passenger side air bag wiring harnesses may become damaged over time caused by seat adjustment. This could impair the deploym…
Due to a software issue with the airbag control unit, the pedestrian detection sensor may not function as intended.
Due to a manufacturing defect, under certain conditions the engine valve springs may crack. If this occurs, the engine could stall resulting in a loss of motive power.
The courtesy lamps, fog lamps and daytime running lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 13/00 - Installation of…
The side direction indicator lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 06/00 - Direction Indicators.The courtesy la…
The courtesy lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 13/00 - Installation of Lighting and Light-signalling Device…
The side direction indicator lamps fitted in the vehicle do not comply with the requirements set out under Australian Design Rule (ADR) 06/00 - Direction Indicators.The courtesy la…