Every safety recall published by the Australian government, searchable and filterable.
Involved vehicles have had the passenger’s front air bag inflator replaced as part of the Takata inflator recall campaign.There is a possibility that in some vehicles the replaceme…
The scooter frame could flex under certain conditions and subsequently cause cracking of the frame in a particular area.
The vehicle brake switches may malfunction. This can be identified by the illumination of a Malfunction Indicator Lamp (MIL), an audible chime, and the brake lights will be illumi…
On affected vehicles, the cooling strategy and maximum temperature alert might cause engine overheating.
Possibility of brake disc fasteners becoming loose.
A fracture on the fuel feed hose connector may cause the fuel feed hose to disconnect and leak fuel.
On affected vehicles, the cooling strategy and maximum temperature alert might cause engine overheating.
On affected vehicles, the passenger airbag may not be filled with the required volume of gas. This has occurred due to a production fault leading to a defective weld joint on the g…
There is a manufacturing defect in the ABS circuit board with a risk of short circuiting when in contact with water.
In some variants of each of the affected models there is a socket outlet (power point or GPO) located too close to the sink, in breach of the Australian Standard AS/NZS3000:2007.
Water may enter between the hood and windshield and cause the front wiper link ball joint to corrode, resulting in the wiper link separating and the wipers becoming inoperative.
The sunroof glass outer frame adhesive may become weak due to inappropriate resin material. As a result the sunroof glass may detach from the outer frame when driving.
The engine auto tensioner flange may crack under high load driving conditions, which may cause the drive-belt to fall off.
All vehicles are subject to condition a) whilst only some vehicles are subject to condition b)a) Improper sealing of parking brake caliper may allow water entry, causing rust on th…
The system comprising of the fuel tank, fuel tank filler neck and fuel tank filler neck gasket may leak and fuel may escape.
The high pressure fuel pumps could be damaged under specific operating conditions. This damage can lead to abnormal noise and vibration and, over time, can cause the pumps to devel…
The propellant mix of certain front seat belt tensioner squibs may not meet the specifications.
On all 2016, 2017 and some 2018 ZX-10R and ZX-10RR models, the durability of some transmission gears may not be sufficient.
The piston component material made of PPS (polyphenylene sulphide) located in handbrake master cylinder (front brake), may crack.
On the affected model motorcycles, if the brake fluid is not flushed for a prolonged period of time beyond the 2 year schedule specified in the Owner’s Manual and Service Manual, a…
The engine management software on these Thruxton model motorcycles may not always prevent 'blip stalling'; the ability to maintain a stable engine idle when the throttle is opened…
Jayco Iveco Motorhomes with a Cummins Onan generator fitted may have a condition that allows the fuel line from the petrol tank in the storage locker to the generator to sag into p…
The driver airbag could be triggered without obvious cause. This is due to electrostatic discharge if the steering column is not sufficiently grounded and the steering column switc…
Driver's airbag inflator: If an affected vehicle is involved in an accident and the airbag goes off, the airbag inflator may rupture.
Affected vehicles are equipped with an airbag system that uses pressure sensors and/or G sensors to detect impact to the vehicle. There is a possibility that the insulation layers…