Every safety recall published by the Australian government, searchable and filterable.
The spiral cables' electrical connection for the driver's side airbag module may become damaged over time. If this occurs, the airbag warning light will illuminate and the driver'…
The seat belt tongue may bind in the seat belt buckle. Consequently, when the seat belt release button is pressed, the belt may not release immediately.
On certain Mazda6 (GJ) vehicles, the Powertrain Control Module (PCM) may function incorrectly, ceasing to charge the battery. This will illuminate the 'Charging system warning ligh…
A production fault has resulted in some side stands switches that are not correctly sealed.
Holden has identified a condition where, potentially the Brake/Stop lamps may illuminate for a short period of time without the brake pedal being depressed.
Affected vehicles may exhibit friction wear on the driver's seat wiring harness. potentially causing an electrical malfunction or localised overheating.
It is possible, after prolonged race track like use that the toe link may fracture and separate from the rear sub frame.
Right hand tubular driveshaft may fracture and separate causing sudden loss of driving power.
The left rear positioning light may stop functioning as a result of a software failure. The error will illumiate the 'bulb failure light' and display a message in the Drivers Info…
Under certain conditions the flexible brake hose bracket located on the front differential may fracture around the securing bolt and break, possibly resulting in the leakage of bra…
The Ready Alert Braking System (RAB) may result in the driver experiencing a hard brake pedal feel.
There is a possibility that an O-ring seal located between the Fuel Delivery Module and the wiring connector insert of the LPG tank may be missing.
There is a possibility that an O-ring seal located between the Fuel Delivery Module and the wiring connector insert of the LPG tank may be missing.
Due to electrolysis in the gearbox, the sulphur constituents in the synthetic oil can separate. These accumulations settle between the conductor paths of the electronics in the fo…
On some Caddy vehicles the attachments of the ball pin for the gas pressure spring on the D pillar can loosen. It cannot be ruled out that the ball pin will subsequently tear off b…
During production a machining error on the clutch drum has led to the possiblity that a snap ring could displace. This may lead to transmission clutch slippage and result in the ve…
Due to overheating, the indicators may function incorrectly.
Due to incorrect material used and routing of the fuel tank breather tube (main to sub-tank) near the exhaust, the breather tube may be damaged by heat from the exhaust which could…
Due to overheating, the headlight may function incorrectly.
Due to overheating, the headlight may function incorrectly.
Due to an incorrect procedure during manufacture of the Rocker Arm Shaft Sealing Bolt, it may come loose causing oil to leak from the engine.
The software used to control the boost converter contained within the hybrid system intelligent power module, during high-load driving such as accelerating from a stop, may cause h…
In extremely cold conditions, the compressed air system air dryer breather may ice up and become blocked. A blocked breather will result in a pressure increase in the air dryer, wh…
Overseas models fitted with the same cabin are experiencing “de-lamination” of the sun visor supports which can lead to detachment of the visor.
There is a possibility that the oil level in the rear differential is not within specification.