Every safety recall published by the Australian government, searchable and filterable.
Vehicles may have been manufactured with Anti-lock Braking System (ABS) actuator with an oil seal that may leak brake fluid internally.
A clip on the fuel hose bundle may rub on the fuel pump return hose, which could cause a fuel leak.
The O-ring on the fuel pump may have become twisted during the installation process. If the seal has been twisted, it may reduce the performance of the seal.
The subject vehicles utilise software to control the hybrid system. This software is designed to put the system into a fail-safe mode, illuminating various warning lights, displayi…
Audi R8 vehicles could have a possible oil leakage in the gearbox breather when the vehicle is being driven on a racetrack and extreme driving manoeuvres are being undertaken.
During assembly, two nuts for mounting busbars in the prefuse box located in the vehicle's trunk may not have been installed.
The fault affects the crash protection plate of the high pressure fuel pump in the engine compartment. Due to an error in the releasing process in an engine production plant, a cra…
Due to a possible mismatch of software and hardware within the airbag control, the front airbags may be activated whilst parking the vehicle. The affected vehicles are required to…
On affected vehicles, the airbag gas generator housing may eject metal parts if the airbags are deployed.
The improper welding between the centre stand spring mounting pin and left side centre stand bracket may cause the pin to shift or fall off resulting in the centre stand spring det…
The software that determines the classification of the front passenger may not function correctly. This may result in an installed child seat being identified as a person, or a sma…
The vehicles have improper programming in the ECU (controls the hybrid system and transmission), when the accelerator pedal is depressed quickly during normal driving conditions, t…
Affected vehicles have an engine wire harness connected to the hybrid vehicle Power Control Unit located within the engine compartment. A portion of the wire harness could contact…
Oil foam may develop in the system's oil reservoir under dynamic operating conditions if the oil is below the minimum level. This may cause oil to escape via the ventilation bores…
The rear-brake caliper pistons may contain trapped hydrogen gas that could be released into the vehicle’s brake system.
Certain MY18 Tiguan Allspace models from a limited production period may contain a defective passenger airbag. When the passenger airbag module was manufactured, the airbag may hav…
The wiring harness of the SRS electronic control unit could become severed if the vehicle is in a severe collision.
The rear brake calipers may have incorrect chrome coating on the pistons, which may cause gas pockets to form in the brake system. In some instances, the brake pedal may exhibit in…
On certain vehicles, after several hard brake applications, the brake light pressure switch may not activate the brake lights with a light application of the brake pedal.
If the powertain control module fails, the driver may experience a no-start, a start-and-immediate stall condition, or an engine stall while driving.
The auxiliary heater element in the air conditioner may fail as a result of overheating in the area of the connectors.
The left cutout for the exhaust system is missing in some incorrectly installed paneling.
The auxiliary heater element in the air conditioner may fail as the result of overheating in the area of the connectors.
If the motorcycle is used continuously at high speed, the heat generated may cause the clutch basket to break.
The seatbelt buckles for the rear right and rear centre seating positions may have been torqued incorrectly.