Every safety recall published by the Australian government, searchable and filterable.
Some vehicles equipped with Adaptive Cruise Control (ACC) may not allow the driver to cancel ACC in very specific driving conditions.
It is possible that the vehicles may mistakenly detect a correctly engaged seat belt as being not engaged. A warning tone and a warning symbol in the instrument cluster will inform…
The clutch cable may contact the main harness sheath, potentially causing damage to the wiring within the harness. If this condition occurs and remains undetected, it may lead to a…
It is possible that the vehicles may mistakenly detect a correctly engaged seat belt as being not engaged. A warning tone and a warning symbol in the instrument cluster will inform…
During testing, there was greater than expected variation in CO2 emissions between vehicles.
The vehicle's engine may experience fuel starvation and temporary loss of engine performance.
The airflow sensor located within the petrol engine may fail. Failure of the airflow sensor will be indicated by a deterioration in vehicle performance, causing the EV system warni…
Due to an issue with the car's software, the red brake wear warning light is not illuminated continuously when the brake pads are worn out. Only a yellow warning message is shown i…
On certain vehicles, it is possible that fuel may escape from one or both fuel rails (low-pressure side).
Tyres of the type “Sport Maxx RT Noise Shield 265/30 ZR 20”, which were supplied by the Dunlop company, do not fully comply with the approval test requirements of UN/ECE R30 which…
Due to an issue with the car's software, the red brake wear warning light is not illuminated continuously when the brake pads are worn out. Only a yellow warning message is shown i…
Affected vehicles may have foreign debris inside the steering shaft rubber boot.
Incorrect compliance label specifying the vehicle load capacity differs from production information and may state a Gross Vehicle Mass rating in excess of the vehicle’s capacity.
The adjuster nut for the handbrake lever can loosen. This may prevent the handbrake from being fully applied.
The right hand side spoiler on the rear-end door may not have been tightened according to specifications.
Vehicles are equipped with run-flat tyres with a sidewall reinforcement layer inside the tyre. Due to an improper assembly process, a crack may develop on the tyre sidewall reinfo…
In a frontal collision, the lower longitudinal crash beam in the luggage compartment area could penetrate the bulkhead wall at the lower cross body component.
The welded connection of the rear seat bench may not have been correctly connected.
The Stop Light Switch may be affected by contaminants from outside the vehicle and could cause electrical contact points to malfunction.
Affected vehicles have been fitted with an oil pipe with a smaller interior pipe diameter than required. This may result in insufficient oil supply to the turbocharger’s turbine be…
Individual bolted connections on the front axle may not have been tightened to the specified torque.
On some vehicles during the manufacturing process of the fuel lines, the lines may have been damaged, possibly resulting in a fuel leak.
An internal component within the clutch assembly may fail, preventing clutch disengagement which could result in the transmission failing to engage neutral when commanded by the dr…
The ABS hydraulic unit may have been contaminated with debris during the manufacturing process.
An error occurred in the moulding process of the fuel tank. There may be a fuel leakage at the lower fitting insert for the fuel tank fairing in the seat area.